Total length of the table working surface
Total length of the table working surface - 3000 mm. screen with bottom illumination - 560 mm. blank surface (laminated chipboard) - 2440 mm.
Maximum bale weight
60 m² living area
Automatic material stretch tracking system
Stretch control function, allows rewinding and accurate metre measurement of slightly elastic materials.
Maximum electrical power consumed by the machine
6 l
Maximum bale diameter
400 mm
Electronic programmable counter for material length measurement
The electronic meter meter allows you to: use conversion factors that allow you to increase the accuracy of measuring materials of different densities and stretching; - non-volatile power supply of the meter ensures the preservation of the worked
Automatic bale edge equalization system
function ensures that the edge of the material roll is aligned to the base side (except for curled edge webs).
Touch screen rotary operator panel
the machine is controlled from the operator's touch panel, which is designed in Russian.
Foot-operated rear and front foot controls
The foot pedal is necessary for easy filling of the machine. the rear pedal switches on the drives of the unwinding rollers. the front pedal is used for switching on and off the drives in the machine in case of defects or other technological reasons.
Rewinding scheme
from a cylindrical roll wound on a cardboard bobbin into a cylindrical roll wound on a cardboard bobbin with an outer diameter of at least 40 mm.
Reverse (Reverse)
The backstroke function is used for rewinding back the material in case of a missed/clarified defect or if the residual material has been rewound into a roll.
Machine stop sensor at the end of the bale
the bale end sensor is necessary to increase the measuring accuracy. upon opening the bale end sensor, the machine resets the rewind speed to 5 m/min and the operator finishes the rewind at a low rewind speed.
Additional unwinding axis for handling non-cylindrical bales on the cardboard bobbin inside
The axle is necessary for working with non-cylindrical bales on the bobbin. when using the "axle rewind" function, the machine automatically switches off the drive of the unwinding rollers in order to save energy consumption.
Overall dimensions (length x width), mm for machine with bale width up to 1800 mm
4050x2500
Mains power supply
220 thousand m³
Additional overhead lighting for the entire 3-meter work surface of the table
The optional overhead lighting allows specific types of defects such as variation in shade and non-colouring to be detected in reflected light on the material.
Ruler for visual measurement of fabric widths
required for visual measurement of bale width when machine is stopped.
3-meter longitudinal ruler
required for visual measurement of bale length when machine stops
Marker
The marker allows automatic chalk marking of the material according to a preset metre, e.g. after reaching 3.
Passport, operating and maintenance instructions
supplied with equipment
