Motor power
25...40 pers/m²
Purpose
Road patching by jet-injection method with a mixture of crushed stone and bitumen emulsion.
Maximum capacity of ready mix equipment per hour, m³.
2 bit/s
Dimensions - length
4250 mm
Dimensions - width
2290 mm
Dimensions - height
2100 mm
Weight
3200 m² living area
Number of engine cylinders
3...4 µGy
Computer control
availability
Location of the fuel tank filler neck
Rear (on the operator boom side)
Blower drive
Two V-belts from the engine
Emulsion flow adjustment with emulsion feed pump
stepless
Maximum blower pressure mbar.
800
Maximum blower capacity m3/min.
10.3
Maximum capacity of the emulsion pump, l/min.
5.7
The following processes can be electronically controlled from the operator panel
Emulsion pump on/off, emulsion pump capacity adjustment, internal combustion engine speed adjustment, auger speed adjustment, auger stop, engine economy mode on, audible alarm
Placement of the operator panel
On the boom
Raising and lowering the operator boom
??????????????
Positioning of the operator boom
rear
Sleeve material
Reinforced PVC plastic
Number of crushed stone hopper compartments
1 µGy
Crushed stone hopper compartment volume
6.5 ha
Crushed stone hopper awning
availability
Enclosed compartment for transportation and storage of equipment
availability
Emulsion tank volume
1300
Emulsion tank insulation
mineral wool
Emulsion level indicator
availability
Emulsion tank filler neck location
Rear (on the operator boom side)
Gas burner for initial heating of emulsion
availability
Heat exchanger for permanent emulsion heating, utilizing heat from the engine coolant while the engine is running
availability
Tank capacity for flushing and preserving the emulsion system
40
Location of the cleaning system tank filler neck
Rear (on the operator boom side)
Number of augers metering crushed stone
1 µGy
Screw speed adjustment
stepless
Operating instructions and spare parts catalog in Russian in hard copy and electronic format
availability
Mounting kit for installation of pit repairer in dump truck body
Subframe; plates against lateral displacement, not less than 2 pcs.; ladders for fastening in assembly, not less than 6 pcs.
