Output power in automatic matching mode for 1 kOhm load resistance of KP-Tg Generator, not less than
10 W
Depth of KP-Tp Receiver trace, up to
5 m
Sensitivity of the KP-Tp Receiver at maximum gain, not less than
at least 25 µV
Maximum current consumption of the KP-Tg Generator load
2 A
Rated supply voltage of Generator KP-Tg
B1/B8 2100/900 MHz V
Duration of pause between KP-Tg Generator parcels
0.29
KP-Tg generator signal sending period
1.92
Output power in the automatic matching mode for 50 ohm load resistance of Generator KP-Tg, not less
2 W
Maximum power delivered to the line in manual power control mode (with load impedance >100 ohms) Generator K
20 W
Effective matching resistance range of KP-Tg Generator
1...1000 ohm
Operating frequencies of the KP-Tg Generator
(50;273.5;420;480;580;720;780) ± 0.5;(2187.5;5500;10000) ± 1
The generator has a
automatic protection of the electrical circuit from failure during strong load resistance surges
In device provided
display of current voltage, load current, signal power and load resistance. if the voltage set at the generator output is too low for high resistance measurements (if the load resistance is higher than the generator can measure
KP-Tg has 3 modes of operation
- HF (continuous high-frequency signal generation); - HF-P (high-frequency signal generation with pause); - LF-HF-P (low and high-frequency signal generation with pause); in these modes, both smooth manual power adjustment and automatic adjustment are poss
The KP-Tg generator is a
a generator with automatic output signal power adjustment (auto line matching) and designed to output special signals into communication lines for subsequent determination of the route and depth using a receiver (kp-tp)
The KP-Tp receiver is structurally designed as a
the receiver KP-Tp is made as a portable unit from aluminum alloy. inside the unit, there is a lithium-polymer battery for powering the device.
Cable trace detection indication in two ways
by level change on indicator and presence of acoustic signal
Accuracy of KP-Tp Receiver trace determination at the depth of 0.8 m, not more than 0.8 m
15 cm
Sensitivity of the KP-Tp Receiver at minimum gain, not less
at least 75 mV
Bandwidth of KP-Tp Receiver
4...160
Operating frequencies of Receiver KP-Tp
25
Power supply voltage for KP-Tp Receiver
3.7 V
Current consumption of the KP-Tp Receiver, not more than
130 mA
Overall dimensions of the receiver, not more than
127 x 60 x 28 mm
Dimensions of receiving antenna, max.
1040 x 155 x 125 mm
Weight of receiver, not more
0.65 kg
Weight of receiving antenna, not more
0.45 kg
Overall dimensions of the generator, not more
120 x 60 x 150 mm
Weight of the generator, not more than
2 kg