Power supply for handpieces
Li-Po battery pack (2x3.7V; 800mAh) charging from charging station
Operating temperature in modes
- gutta-percha trimming 'CUT' - 170 +/- 10 °C, - gutta-percha condensation 'PACK' - 120 +/- 10 °C, - thermal activation of irrigant 'MIX' - 50 +/- 5 °C
Accuracy of stabilisation of Estus Pack operating temperature
2 °C
Maximum duration of the thermoplugger heating cycle with subsequent automatic shutdown in modes
- gutta-percha cutting 'CUT' - 10 sec. - gutta-percha condensation 'PACK' - 20 sec - thermal activation of irrigant 'MIX' - 120 sec.
Estus Pack tip runtime with a new fully charged battery pack without recharging.
at least 500 heating cycles
Operating temperature of Estus Fill tip
180 °C
Accuracy of operating temperature stabilisation in Estus Fill
10 °C
Time of maintaining the operating temperature in Estus Fill in "standby" mode
3
Estus Fill operating time with a new fully charged battery pack without recharging.
13-15 heating cycles of 3 min
Time of operation of handpieces in the "standby" mode before automatic power failure
10
Overall dimensions of the Estus Pack nozzle
(207*33*43) ±3 mm
Weight of Estus Pack tip
80 year
Overall dimensions of Estus Fill tip
(240*33*43) ±3 mm
Weight of Estus Fill tip
115 year
Protection against electric shock for lugs
device with internal power source. type B working part
Built-in NF-03 radio module in the tips
2.4-2.525 GHz, max output power - +7 dBm, range - up to 3 m line of sight
Overall dimensions of "Estus Energy-D" charging station
(87*56*49) ±3 mm
Weight of Estus Energy-D charging station
145 year
Parameters of the charging station power supply unit
Input voltage (100-240) V, ~50/60Hz, Output voltage 5V; max. 2.4 A.
Overall dimensions of the Estus Two-B stand
(102*100*40) ±3 mm
Weight of "Estus Two-B" stand
One link up to 16GB 64-bit DDR4-2400 MHz with ECC support; 16GB (for CPC1309-01); 8GB (for CPC1309-02) year
Adjustment of the working temperature of the Estus Pack handpiece in "PACK" mode in conjunction with the ESTUS MULTI control uni
80...120 °C
Adjustment of the Estus Fill handpiece operating temperature in conjunction with the ESTUS MULTI control unit.
160...200 °C
Max. time for full charging of handpiece battery packs
3
Max. injection needle tip temperature
75 °C
Max. temperature of the external surface of the heater Estus Fill
45 °C
Average time to heat Estus Fill from 20 deg. C to 180 deg. ?
15
Max. time to heat the thermoplugger to the set operating temperature
3
Time of extrusion of whole gutta-percha rod in Estus Fill with accuracy +/- 10 sec.
- for "high" speed level - 30 sec; - for "middle" speed level - 65 sec; - for "low" speed level - 140 sec