Power supply for handpieces
锂聚合物电池组(2x3.7V;800mAh)通过充电站充电
Operating temperature in modes
- 橡胶修剪'CUT' - 170 +/- 10 °C, - 橡胶冷凝'PACK' - 120 +/- 10 °C, - 灌溉剂的热激活'MIX' - 50 +/- 5 °C
Accuracy of stabilisation of Estus Pack operating temperature
2 °C
Maximum duration of the thermoplugger heating cycle with subsequent automatic shutdown in modes
- 橡胶切割 'CUT' - 10秒。- 橡胶冷凝 'PACK' - 20秒 - 灌溉剂热激活 'MIX' - 120秒。
Estus Pack tip runtime with a new fully charged battery pack without recharging.
至少500个加热周期
Operating temperature of Estus Fill tip
180 °C
Accuracy of operating temperature stabilisation in Estus Fill
10 °C
Time of maintaining the operating temperature in Estus Fill in "standby" mode
3
Estus Fill operating time with a new fully charged battery pack without recharging.
13-15个加热周期,每个3分钟
Time of operation of handpieces in the "standby" mode before automatic power failure
10
Overall dimensions of the Estus Pack nozzle
(207*33*43) ±3 毫米
Weight of Estus Pack tip
80 year
Overall dimensions of Estus Fill tip
(240*33*43) ±3 毫米
Weight of Estus Fill tip
115 year
Protection against electric shock for lugs
带内部电源的设备。B型工作部分
Built-in NF-03 radio module in the tips
2.4-2.525 GHz,最大输出功率 - +7 dBm,作用范围 - 直线视距达 3 米
Overall dimensions of "Estus Energy-D" charging station
(87*56*49) ±3 毫米
Weight of Estus Energy-D charging station
145 year
Parameters of the charging station power supply unit
输入电压 (100-240) V,~50/60Hz,输出电压 5V;最大 2.4 A.
Overall dimensions of the Estus Two-B stand
(102*100*40) ±3 毫米
Weight of "Estus Two-B" stand
One link up to 16GB 64-bit DDR4-2400 MHz with ECC support; 16GB (for CPC1309-01); 8GB (for CPC1309-02) year
Adjustment of the working temperature of the Estus Pack handpiece in "PACK" mode in conjunction with the ESTUS MULTI control uni
80...120 °C
Adjustment of the Estus Fill handpiece operating temperature in conjunction with the ESTUS MULTI control unit.
160...200 °C
Max. time for full charging of handpiece battery packs
3
Max. injection needle tip temperature
75 °C
Max. temperature of the external surface of the heater Estus Fill
45 °C
Average time to heat Estus Fill from 20 deg. C to 180 deg. ?
15
Max. time to heat the thermoplugger to the set operating temperature
3
Time of extrusion of whole gutta-percha rod in Estus Fill with accuracy +/- 10 sec.
- 对于“高”速级别 - 30 秒; - 对于“中”速级别 - 65 秒; - 对于“低”速级别 - 140 秒