Pupil's table AGAT 01.03.02.05 (two-seater, height)

Consists of 2 supports made of flat-oval tube with section 40x20x1,5 mm and 2 traverses made of flat-oval tube with section 30x15x1,5 mm.In the inner part of the radius bend there is a "stream" of rigidity.On the outer side of the support bend an angle of metal plate 107x13x1,5 mm is welded.On each support 2 plates are welded from the top and back of the support, the size of 30x35x2 mm.In the middle of the two beams, a bent L-shaped blank made of 40x20x1.5mm flat-oval pipe is fixed by welding.All visible holes in the pipe are closed with plastic plugs.A plastic corner support 110x95x25mm is fixed to the corner, on the outside of the table leg bend.Plastic lugs 65x45x25mm are put on the front edge of the supports.2 hooks.The cover of the LDSP is made of a metal plate 107x13x1.5mm. Hooks.LDFP cover 22 mm. The end surfaces of the table top, pencil case are covered with 5 mm thick polypropylene. The polypropylene edge and the pencil case are made by casting, tightly fit and repeat all the contours of the table top.16mm LDPE arch with aluminium profile insert